Hettich

Hettich OrgaTray 440 Cutlery Insert

$36.95

The insert that trims on both sides — so it sits centred in the drawer rather than pushed to one edge.

This cutlery insert is moulded in polypropylene at 55mm high, sized for Hettich ArciTech and InnoTech Atira drawers and suited to most other systems of the same depth. It is supplied at 520mm deep and trims down to 440mm, making it suitable for drawers between those measurements. Choose from the available finish options.

Which size do I order?

Order by the inside width of your drawer — measure side to side inside the drawer box, not the cabinet size or drawer front. Each option is supplied at the top of its range and trims down to the bottom of it.

Your drawer measures Tray is supplied Trims down to
201–250mm 250mm wide 201mm
251–300mm 300mm wide 251mm
301–350mm 350mm wide 301mm
351–400mm 400mm wide 351mm
401–450mm 450mm wide 401mm
451–500mm 500mm wide 451mm
501–600mm 600mm wide 501mm
601–700mm 700mm wide 601mm
701–800mm 800mm wide 701mm
801–900mm 900mm wide 801mm
901–1000mm 1000mm wide 901mm
1091–1150mm 1150mm wide 1091mm

Before you order — check all four

  1. Inside width: measure side to side inside the drawer box.
  2. Inside depth: anything from 441mm to 520mm is covered.
  3. Inside height: allow 55mm clear from the drawer base.
  4. If between ranges: take the larger option; material can come off, but it cannot be replaced.

Can it be cut down?

Yes, and evenly on both sides. Measure the opening, mark the tray, then remove half the difference from each edge so the compartments remain centred. Score several times with a sharp blade against a steel rule, snap over a bench edge and smooth the cut.

Product details

  • Material: moulded polypropylene
  • Available finishes: light and dark options
  • Height: 55mm
  • Depth: 520mm supplied, trims to 440mm
  • Twelve widths covering drawer openings from 201mm to 1150mm
  • Suits Hettich ArciTech, InnoTech Atira and other systems of matching depth